Golden 24 hours principle ----all the responses should be done within 24 hours!Step.1 Order Step.2 DFMEA Step.3 Tooling BOM Form Step.4 Tooling 2D DrawingStep.5 Cutting Tooling Notice Step.6 Weekly Report Step.7 Tooling 3D drawing Step.8 Dimension Report of T1 sampleStep.9 Packing Information Step.10 CDStep.11 3000 cycles testing for toolin...

Step.1 Order1. Confirm Order2. Issuer PI3. Provide Engineers with part drawings and special requirements

Step.2 DFMEADFMEA(Design Failure Mode & Effect Analysis ) should be prepared before the 2D tooling design ,which should include P/L, Gate location, Ejector pins and the basic structure of tooling as well as the comments for any parts design defects. This is a good way to save much time and cost for tooling design and fabrication.

DFMEA REPORT SHOW ...

DFMEA REPORT SHOW ...

BOM Form Longxiang Group Limited Mold information Longxiang Project No 　 Basic information 　 Mold basic information 　 Project No. 　 Mold base brand 　 　 Mold base level 　 ...

Tooling 2D drawing

Cutting Tooling Noticd Cutting Tooling Steel Notice P.O Tooling No. Resin Color Shrinkage Rate Tooling core Surface of ...

Weekly Report 　 　 　 　 　 　 　 　 Project Name: LXGL182 　 P.O.Date: 2-Apr-18 　 T1 Date: 30-Apr-18 　 Report Date: 2-Apr-17 　 　 　 　 　 This is a weekly ...

3D drawing

Dimension Report of T1

Packing Information

CDContents: 1. Tooling 2D 2. Tooling 3D 3. Dimension Report 4. Photograph 5. Video

3000 cycles testing for tooling ejecting system

Plastic Mould Operation Manual