The important consideration should be end product and what your definition of "REGRIND" is. Reprocessing your own internal scrap (if kept clean and uncontaminated with anything else) is a significantly different question basis than using unknown or unclassified "regrind" from outside sources.As to the end ...

It's a small plastic injected piece that will be submitted to short period of time (2 seconds) of high temperature (95-105ºC approx.) in every cycle; this high temperature is produced by a filament where electric current passes through (like a house light bulb but hotter) for no mo...

Plastic MaterialFeaturesApplicable products POMLow friction coefficient,Good geometric stabilityEspecially suitable for the production of gear and bearing PA PA6Good elasticity,High impact strength,Water absorption is biggerSuitable for making general machinery parts, reduce friction wear parts, trans...